Battery Backup AIO (All In One) UPS (Uninterruptible Power Supply), Power Line Conditioner, Voltage Regulator, And Surge Protector For PCR (Polymerase Chain Reaction) Instruments

$ 1,399.99

The Battery Backup Power, Inc. AIO (all in one) UPS (uninterruptible power supply), power line conditioner, voltage regulator, and surge protector for PCR (polymerase chain reaction) instruments provides complete power protection.  

This system has the combined capabilities of what is typically three separate devices:

1. Advanced UPS (uninterruptible power supply) - Once plugged in and turned on, this system synchronizes internal battery power with utility power which allows a seamless transfer to backup power alone if utility power is lost. This differs from consumer UPS systems which may take up to 12 milliseconds to recognize an outage and engage backup power. 

2. Power Line Conditioner - There are 3 user programmable modes (Normal, ECO, and CVCF). CVCF mode is Constant Voltage Constant Frequency output. This mode keeps the output at 120 Volts 60 Hertz no matter what the input voltage or frequency is. The usable input voltage range is 55-150 volts AC while the usable frequency range is 44-66 Hz. Outside of this range, the unit will run on battery power until depleted and then cleanly shut off power. This mode also allows the unit to act as a power line conditioner for diesel and natural gas generators. CVCF mode is set by the factory before shipping when ordered from this website specifically for PCR instruments.

3. Surge Protector and Power Strip - In the event of a significant surge, the circuit breaker (bottom left on back) will trip cutting off the device from the dangerous power surge. The circuit breaker will need to be manually pressed and the unit restarted after a significant surge to restore normal operation. This system protects the attached equipment from dangerous voltage spikes and surges. Using a single wall plug, this unit allows up to 8 separate devices to be plugged in. 

*Only a single PCR should be plugged into each Battery Backup AIO, but there is adequate capacity for accessory devices such as a computer, monitor, or robot arm. At no time should a laser printer be plugged into this device. 
 


Need help with a different type of instrument? Email our engineering team at engineering@batterybackuppower.com

Approximate Backup Time Chart:

 Instrument AIO Only (Option 1) AIO + EBP (Option 2) AIO + 2 EBPs (Option 3)
QuantStudio 3 13 Minutes 39 Minutes 1 Hour 6 Minutes
QuantStudio 5 13 Minutes 39 Minutes 1 Hour 6 Minutes
QuantStudio 6 Flex 13 Minutes 39 Minutes 1 Hour 6 Minutes
QuantStudio 7 Flex 13 Minutes 39 Minutes 1 Hour 6 Minutes
QuantStudio 12 Flex 11 Minutes 34 Minutes 57 Minutes


Model Numbers And Options:

Model Number: Description (Under Battery Options Drop Down):
BBP-AR-2000-PSW-ONL AIO With Internal Batteries Only
BBP-AR-2000-PSW-ONL-WEBP AIO Plus 1 Extra External Battery Pack
BBP-AR-2000-PSW-ONL-W2EBP AIO Plus 2 Extra External Battery Packs

 

  • 2000 VA (2 kVA) / 1,800 Watt (1.8 kW)
  • 55-150 Volt AC Input / 100/110/115/120/127 Volt AC Output
  • Energy Efficient/High Efficiency UPS Mode >96.5% Efficiency When Enabled
  • LCD Status Measurements Include Voltage, Frequency, Load Level, Battery Level, Output Current, and Estimated Remaining Backup Time
  • Tower
  • Pure Sine Wave Clean Output To Operate And Maximize The Life Of Even The Most Sensitive Electronics
  • Online (Double Conversion) - Highest Level Of Protection Available - Battery Power Always Engaged, No Switching Delay (Phase Locked To Input Power Source)
  • Wide Frequency Input Range (44-66 Hz Auto Sensing) Allows For Generator Power To Be Used As A Primary Or Secondary Input Power Source (Using Automatic Transfer Switch Before UPS)
  • Constant Voltage Regulation (±1%)
  • Constant Frequency Regulation (±1 or ±3% Selectable)
  • Factory Warranty: 3 Years On Electronics And 1 Year Warranty On Batteries
  • Optional Extended Warranty: 5 Years On Electronics And 1 Year Warranty On Batteries
  • Digital Signal Processing (DSP) Allows For Greater Reliability Over Older UPS Designs And Superior Electric Noise Filtration
  • >0.99 Input Power Factor / 0.92 Output Power Factor (Line Mode) / 0.965 Output Power Factor (High Efficiency Mode) For Superior Efficiency And Power Savings
  • INPUT: 120 Volt, 20 Amp NEMA 5-20P (Plug)
  • OUTPUT: 8x 120 Volt, NEMA 5-15/20R Battery & Surge Protected Receptacles (Standard Wall Receptacles) 
  • Full Load (1,800 Watts) Estimated Run Time On Battery Power:
    • Up To 11 Minutes On Internal Batteries
      • 4 Batteries, 12 Volts, 9 Amp Hours Each
    • Up To 35 Minutes On Internal Batteries + 1 Battery Pack
      • 12 Batteries, 12 Volts, 9 Amp Hours Each
    • Up To 58 Minutes On Internal Batteries + 2 Battery Packs
      • 20 Batteries, 12 Volts, 9 Amp Hours Each
  • Half Load (900 Watts) Estimated Run Time On Battery Power:
    • Up To 23 Minutes On Internal Batteries
      • 4 Batteries, 12 Volts, 9 Amp Hours Each
    • Up To 1 Hours 09 Minutes On Internal Batteries + 1 Battery Pack
      • 12 Batteries, 12 Volts, 9 Amp Hours Each
    • Up To 1 Hours 56 Minutes On Internal Batteries + 2 Battery Packs
      • 20 Batteries, 12 Volts, 9 Amp Hours Each
  • Weight: 47.4 lbs. (AIO)
  • Dimensions (Inches): 6.73 X 11.3 X 17.4 (W x H x D)
  • Operating Temperature: 32°-104° F
  • Operating Humidity: 20%~95%, Non-Condensing
  • Operating Elevation: 3,280 Feet Without De-Rating 
  • Cold Start Capable (Shipped With Cold Start Disabled, Will Enable Automatically After Receiving Power For The First Time After Shipping)
  • cTUVus, cULus, and FCC Certified
  • Includes Software For Windows Monitoring & Configuration 
  • Free Shipping/Freight Within The United States Or To U.S. Based Freight Forwarder Specified Location (List U.S. Based Location Specified By Forwarder In Shipping Address For International Orders)

User Guides:

-Battery Backup Power Tower UPS User Guide.pdf
-Battery Backup Power Tower External Battery Pack User Guide.pdf

Spec Sheet/Cut Sheet:
-BBP Tower DSP Series Specification Sheet.pdf

Replacement Batteries:
-Leoch DJW12-9.0 (Lead Acid), Yuasa 7.5-12 (Lead Acid), Yuasa REW45-12 (Lead Acid), Or Battery Backup Power BBP-LIFEPO4-HDR-12V-7.2AH (Lithium Iron Phosphate)